Heat Pump Installation in Hillsborough, CA

Hillsborough sits in San Mateo County, on PG&E with Peninsula Clean Energy as the generation provider. Those two facts decide which rebate programs apply, and the housing stock decides what the work actually looks like.

The homes we work on in Hillsborough

Hillsborough is large estates on multi-acre lots, much of it pre-war and heavily remodelled since. Homes this size rarely work on a single system — we design in zones, and equipment often sits a long way from the rooms it serves.

We service every Hillsborough neighborhood including Lower North Hillsborough, Upper North Hillsborough, Tobin Clark, Country Club Manor, Carolands.

The gating factor on most Bay Area heat pump installs is not the equipment, it is the electrical service. A lot of the housing stock here still runs a 100-amp panel, and a whole-home heat pump can push that past its limit once you account for everything else already on it. We check panel capacity and available breaker space at the estimate, and where the numbers are tight we will price both a panel upgrade and a load-management device so you can compare them honestly. The other early decision is what happens to the existing gas furnace: leaving it as backup heat is cheaper up front and keeps the gas line and flue in service, removing it frees space and finishes the electrification. We will lay out both rather than assume.

For Bay Area homes we lean on inverter-driven cold-climate heat pumps from Mitsubishi Electric (Hyper-Heat), Daikin, and Bosch IDS — all of which hold rated capacity into the 30s°F that Bay Area winters routinely deliver. Inland cities like Walnut Creek and San Jose where summer heat is the dominant load lean toward higher-tonnage Carrier Greenspeed and LG LGRED° systems. We pull a Manual J load calculation on every install — Bay Area microclimates vary too much for square-footage sizing.

Hillsborough is in Title-24 climate zone 3, the marine-moderated band: mild summers, heating-dominated load, and a genuine risk of oversizing. An oversized system short-cycles, never runs long enough to dehumidify, and wears itself out faster than a right-sized one.

The rebate landscape here runs through Peninsula Clean Energy. Programs churn — BayREN's Bay-Area-wide appliance rebates ended in 2024, TECH Clean California's single-family incentives are waitlisted, and the federal 25C tax credit expired for equipment placed in service after 2025 — so we quote only programs that are actually paying at estimate time.

We itemize every program your specific equipment qualifies for in writing so you see the net cost, not just the sticker. Utility territory in Hillsborough is PG&E with Peninsula Clean Energy as the generation provider.

heat pump installation that involves equipment replacement, new ductwork, or major electrical work requires a permit through Town of Hillsborough Building Department. PULSE HVAC pulls every permit, files California Title-24 compliance documentation, and coordinates HERS verification (where the scope requires it) on every install. Unpermitted HVAC work shows up in real-estate inspection and can cause headaches at closing — we keep the paperwork clean from day one.

Hillsborough is 112 miles from our Carmichael office from our Carmichael, CA headquarters — about 1 hour 55 minutes. We batch Hillsborough into full-day routes rather than dispatching one-off trucks, which is why appointments book 1–3 business days out and why there is no trip fee attached to the distance. Estimates are in person, on site, and free.

For a genuine emergency during an active heat event or a no-heat winter day, call (916) 850-2221 first — we will tell you honestly whether we can reach Hillsborough in time or point you to a faster local option.

Call (916) 850-2221 to schedule heat pump installation in Hillsborough.